Snorkel XRT33-sn2300+ANSI - Manual

Saf
e
ty Rules and Operating Instructions
Saf
e
ty Rules and Operating Instructions
Operator Manual
WARNING
All personnel shall carefully read, understand and follow all safety rules,
operating instructions, and the Scaffold Industry Association’s MANUAL
OF RESPONSIBILITIES of ANSI A92.6-1999 before operating or
performing maintenance on any UpRight Aerial Work Platform.
Safety Rules
Never operate the machine without first surveying the work area for surface hazards such as holes, drop-
offs, bumps and debris.
Never operate the machine if all guardrails are not properly in place and secured with all fasteners properly
torqued.
Secure chain or gate across entrance after mounting platform.
Never use ladders or scaffolding on the platform.
Never attach overhanging loads or increase platform size.
Look up, down and around for overhead obstructions and electrical conductors.
Distribute all loads evenly on the platform. See the back cover for maximum platform load.
Never use damaged equipment. (Contact UpRight for instructions. See toll-free phone number on back
cover.)
Never change operating or safety systems.
Inspect the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged control
cable, loose wire connections and wheel bolts.
Never climb down elevating assembly with the platform elevated.
Never perform service on machine while platform is elevated without blocking elevating assembly.
Never recharge battery near sparks or open flame; batteries that are being charged emit highly explosive
hydrogen gas.
After Use secure the work platform against unauthorized use by turning key switch off and removing key.
Never replace any component or part with anything other than original UpRight replacement parts without
the manufacturer’s consent.
California Proposition 65 Warning
Gasoline and diesel engine exhaust and some of their constituents are known to the State
of California to cause cancer, birth defects, and other reproductive harm.
NEVER operate the machine within
ten feet of power lines.
THIS MACHINE IS NOT INSULATED
NEVER elevate the platform or drive
the machine while elevated unless
the machine is on firm level surface.
NEVER sit, stand or climb on
guardrail or midrail.
XRT Series
SERIAL NO. 2300 to Current