Snorkel XRT33-sn2300+ANSI - Manual (Page 2)

Page 2 XRT Work Platform
This manual covers all models of the XRT Self Propelled Work Platforms. This manual must be
stored on the machine at all times.
Carefully read, understand and follow all safety rules, operating instructions, labels, and the Scaf-
fold Industry Association’s MANUAL OF RESPONSIBILITIES. Perform the following steps each
day before use.
1. Open module covers and inspect for damage, oil leaks or missing parts.
2. Check the hydraulic oil level sight gauge on the hydraulic tank with the platform fully lowered.
Add hydraulic oil if necessary.
3. Check that fluid level in the battery is correct (see “Battery Maintenance” on page 12).
4. Check the engine oil level and fuel level.
5. Check that all guardrails are in place with all fasteners properly tightened.
6. Check that the slide out deck extension is secured with the pin.
7. Tire Pressure (unless foam filled): 65 psi (4,5 bar).
8. Inspect the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks,
damaged control cable, loose wire connections and wheel bolts.
9. Gasoline / Propane Models: set Dual Fuel Selector to desired position. Set to the center posi-
tion to purge the system when switching fuels. If the machine is to be operated on propane,
open the supply valve on the tank.
NOTE: When using LP gas, use clean, water free liquid petroleum gas, preferably from a
bulk storage tank. Follow the instructions located on the Power Module tray for filling the
tank.
10. While the engine is cool check the engine coolant level.
11. Close and secure module covers.
12. Move the machine, if necessary, to an unobstructed area to allow for full elevation.
13. Pull Chassis Emergency Stop Switch to the ON position.
14. Pull Platform Emergency Stop Switch to the ON position.
I NTRODUCTION
P RE -O PERATION S AFETY I NSPECTION
W A R N I N G ! !
If you smell propane, close the supply valve on the tank immediately until you
have located and corrected the leak
C A U T I O N ! !
DO NOT check coolant when engine or radiator is hot, hot coolant can cause
severe burns.