Snorkel TB50(mfg before 2/1/01) - Manual (Page 41)

7. OPERATION
7 - 3 P/N 0074333
C A U TIO N
If the engine fails to start (at the next step) in 20
seconds, turn the key to OFF and wait 60
seconds before turning the key to START again.
2. Turn the key (3) to START and hold it there
until the engine starts (or for a maximum of 20
seconds) then release the key to ON.
The engine should now be running.
NOTE: If you want to move the platform from
the ground-control station, skip the next
section and go to MOVING THE PLATFORM.
„
STARTING FROM THE PLATFORM-
CONTROL BOX
Before you begin to operate the TB 42/420/50 a
qualified operator must perform the “DAILY
INSPECTION & MAINTENANCE” described in
the chapter by that name in this manual.
Y
Pre-start Conditions
After the DAILY INSPECTION & MAINTENANCE
has been performed, put the TB 42/420/50 into
its pre-start conditions. Pre-start conditions for
operation from the platform-control box are:
1. Set the BATTERY switch (1) to ON (close the
battery-compartment door).
2. Check the circuit breakers (2) to see that none
has popped out (close the engine-compartment
door).