Snorkel TB50(mfg before 2/1/01) - Manual (Page 43)

7. OPERATION
7 - 5 P/N 0074333
C A U TIO N
If the engine fails to start (at the next step) in 20
seconds, turn the ANTI-RESTART MASTER
SWITCH to OFF and wait 60 seconds before
turning the switch to START again.
2. Turn the ANTI-RESTART MASTER SWITCH
(2) to START and hold it there until the engine
starts (or for a maximum of 20 seconds) then
release the switch to ON.
NOTE: Do not step on the foot switch while
you are trying to start the engine.
The engine should now be running.
„
MOVING THE PLATFORM
The engine should already be running (as
described earlier in this chapter) before you start
this section
D A N G E R
Be certain that the space into which you are
about to move the platform, boom, turntable,
and chassis is free of obstructions. Always
look in the direction of movement.
Be careful when operating a TB 42/420/50
within 132 feet (40 meters) of an overhead
electric-power line.
D A N G E R
If you operate from the platform-control box
be sure that the lanyard of your safety belt or
harness is attached to one of the lanyard
anchor points on the platform mount. Also,
be sure the gate is closed behind you.
Each of the ways the platform can move is
shown in the following two-page spread. The
photos show the switches and controllers to use
to move the platform. The switch and controller
call-out numbers (on the left-hand page)
correspond to the illustration numbers on the
right-hand page.
NOTE: At the end of each work day the TB
42/420/50 should be returned to the
STOWED POSITION as described under
STOWING in the “STOWING &
TRANSPORTING” chapter.