1 introduction, 2 operating specifications, Introduction -1 – JLG M400 Operator Manual User Manual
Page 83: Operating specifications -1
SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121644
– JLG Lift –
6-1
SECTION 6. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6.1
INTRODUCTION
This section of the manual provides additional necessary infor-
mation to the operator for proper operation and maintenance of
this machine.
The maintenance portion of this section is intended as informa-
tion to assist the machine operator to perform daily maintenance
tasks only, and does not replace the more thorough Preventive
Maintenance and Inspection Schedule included in the Service
and Maintenance Manual.
Other Publications Available:
Service and Maintenance Manual - ANSI, CSA Spec...........3121645
Illustrated Parts Manual ................................................................3121646
6.2
OPERATING SPECIFICATIONS
Table 6-1. Operating Specifications
Maximum Work Load (Capacity)
ANSI Markets
Unrestricted:
500 lb. (227 kg)
Maximum Work Load (Capacity)
CE & Australia Markets
Unrestricted:
500 lb. (230 kg)
Maximum Travel Grade, Stowed Position
(Gradeability)
2 W/D-30%
Maximum Travel Grade, Stowed Position
(Side Slope)
5 degrees
Platform Height:
40 ft. (12.19 m)
Horizontal Platform Reach (Up & Over)
E400An
E/M400AJP; E/M400AJPn
21 ft.-2 in. (6.41 m.)
22 ft.-5 in.(6.8 m.)
Machine Width:
E/M400AJP
E400An; E/M400AJPn
5 ft.-9 in. (1.75 m.)
4 ft.-11 in. (1.50 m.)
Turning Radius (Outside)
10 ft.-4 in. (3.15 m.)