JLG 1350SJP Service Manual User Manual
Page 416
SECTION 6 - JLG CONTROL SYSTEM
6-40
– JLG Lift –
3121142
HI TILTED -
NO/YES
Displays status of hi tilt input. (Displayed if external tilt sensor is configured)
AUX POWER
OP/CL
Displays the status of the auxiliary power switch input
HORN
OP/CL
Displays the status of the horn input
R FILTER
OP/CL
Displays the status of the return hydraulic filter by-pass switch. Displayed
ONLY if MODEL = 600 (Configuration digit = 3)
C FILTER
OP/CL
Displays measured status of charge pump filter bypass switch. Displayed ONLY
if MODEL = 600 (Configuration digit = 3)
JIB BLOCK
OP/CL
Displays jib block limit switch status. Not displayed if associated configuration
digit = 0
BASKET STOWD
YES/NO
Displays status of basket stowed mode. (Displayed if MODEL NUMBER = 7 or 8)
SOFT LIMIT
OP/CL
Displays status of soft touch limit switch. Not displayed if associated configu-
ration digit = 0
SOFT O/R
OP/CL
Displays status of soft touch override switch. Not displayed if associated con-
figuration digit = 0
GEN SET/WELDER
OP/CL
Displays generator/welder switch input status. Not displayed if associated
configuration digit = 0
LIGHTS
OP/CL
Displays head and tail light switch input status. Not displayed if associated
configuration digit = 0
BSK TILT1
XX.X
Displays indicated platform tilt angle. Displayed on models equipped with
Electronic Platform Leveling.
BSK TILT2
XX.X
Displays indicated platform tilt angle. Displayed on models equipped with
Electronic Platform Leveling.
AXLE RET SW
OP/CL
Displays status of axle extension user switches. (Displayed if MODEL NUMBER
= 7 or 8)
AXLE EXT SW
OP/CL
Displays status of axle retraction user switches. (Displayed if MODEL NUMBER
= 7 or 8)
AXLE LIM SW
RET/EXT
Displays status of axle extension limit switches. (Displayed if MODEL NUMBER
= 7 or 8)
DOS LIM SW
OP/CL
Displays status of Drive Orientation System Limit Switch. (Displayed if MODEL
NUMBER = 7 or 8)
DOS O/R SW
OP/CL
Displays status of Drive Orientation System Override switch. (Displayed if
MODEL NUMBER = 7 or 8)
CAPACITY SW
500/1000
Displays status of capacity selection switch. (Displayed if MODEL NUMBER = 7
or 8)
Table 6-5. Machine Diagnostics Parameters
Diagnostics Submenu
(Displayed on Analyzer
1
st
Line)
Parameter (Displayed on
Analyzer 2
nd
Line)
Parameter Value
(Displayed on Analyzer 2
nd
Line)
Description