JLG 120HX ANSI Operator Manual - Manual (Page 71)

SECTION 6 - EMERGENCY PROCEDURES
3120685 – JLG Lift – 6-3
Righting a Tipped Machine
No attempt should be made to right the machine using
platform or ground controls. a fork truck of suitable capac-
ity or equivalent equipment may be placed under the ele-
vated side of the chassis. A crane or other lifting
equipment may also be used to lift the platform while the
chassis is lowered by a fork truck, jacks, or other means.
Remove all personnel and equipment from the area
before starting operation.
Post Incident Inspection and Repair
Following any incident, thoroughly inspect the machine
and test all functions first from the ground controls, then
from the platform controls. Do not lift above 10 feet (3 m)
until you are sure that all damage has been repaired, if
required, and that all controls are operating correctly.
6.5 INCIDENT NOTIFICATION
It is imperative that JLG Industries, Inc. be notified imme-
diately of any incident involving a JLG product. Even if no
injury or property damage is evident, the factory should
be contacted by telephone and provided with all neces-
sary details.
JLG Phone:877-JLG-SAFE (554-7233)
(8am till 4:45pm EST)
It should be noted that failure to notify the manufacturer of
an incident involving a JLG Industries product within 48
hours of such an occurrence may void any warranty con-
sideration on that particular machine.