Echo EA-410 - Manual (Page 18)

18 X7504220703
© 10/2013 ECHO Inc.
OPERATION EA-410
Starting Cold Engine
1. Place auger on flat surface, recoil starter handle (A) up.
2. Stop Switch
Move stop switch button (B) forward, away from the “STOP” position.
3. Choke Lever
Move choke lever (C) to Cold Start Position ( ).
4. Decompression Button
Press decompression button (D) once.
5. Purge Bulb
Pump purge bulb (E) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5
times.
6. Recoil Starter
Hold support handle securely with one hand, and pull the
recoil starter handle (A) until engine fires (5 or 6 pulls). Do not
hold engine by the throttle handle. DO NOT depress throttle
trigger when starting.
7. Choke Lever
Move the choke lever to the OPEN - RUN position ( )
position.Restart engine if necessary and allow to warm up at
idle for several minutes.
Note: After engine starts, engine decompression button will automatically reset for normal operation.
The auger attachment should not rotate at idle. If attachment rotates, readjust carburetor according
to "Carburetor Adjustment" instructions in this manual or see your ECHO Dealer, otherwise serious
personal injury may result.
Starting Warm Engine
The starting procedure is the same as Cold Start except DO
NOT close the choke.
When engine starts, the auger attachment may rotate, even
with the throttle trigger in idle (released) position.
1. Stop Switch
Move stop switch button (B) forward away from the “STOP”
position.
D
A
D
B
E C
D
A
D
B