Beltronics V990 - Manual (Page 10)

Set and Forget Memory
Any time VECTOR 990 is turned off or unplugged
from the cigarette lighter socket, all feature settings
you have selected are retained in the unit’s memory.
Set and Forget Memory eliminates the need to reset
your preferred feature settings each time your unit is
turned off and then back on.
Reset to Factory Settings
You can reset your unit to factory settings (North
American Mode) for Start-Up mode, volume, DRK, AUD,
CTY and General Selectable Features. To reset, press
and hold the CTY button with the unit on until the
display shows
“ R RE ES SE ET T “
. Two“beeps” will sound and your
unit will cycle through the N NO OR RM MA AL L Start-Up Mode.
DRK (Bright/Dim/Dark) Button
The DRK button allows selection of a bright, fully
adjustable dim or dark mode. VECTOR 990 is
factory preset to full bright display. To engage dim
mode, press and hold the DRK button. The display
will cycle through various levels of dim illumination.
Release the button at your chosen level. To engage
dark mode, press the DRK button a second time.
A single “beep” coupled with the brief illumination
of
“
D DA AR RK K
” on the display confirms your selection.
You’ll notice an “
A Ass
” (AutoScan ™ ), “
H H
” (Highway
mode), “
C C xx
” (City mode) or “
C CA A
” (City ALL)
remains dim to confirm your unit is receiving power.
To return to a full bright setting, press the DRK
button a third time; two “beeps” confirm this
selection. Use of the DRK button does not affect
audio alerts.
Important—if you press the the DRK button and do not
receive audible confirmation, the audio level has been set
too low.
8
k
k
k