ACU-RITE CSS I/O Users Manual - Manual (Page 15)

CSS I/O 13
I - 2 Spindle Speed Contr
o
l (RPM)
A tool can be run from the tool table, or by pressing enter after defining
the spindle parameters for a tool.
Mill Spindle Feature Run
„ With all tool, job, and installation setups entered, the Mill Spindle job
can be run by toggling the Spindle ON/OFF soft key.
„ Select the tool to be used, and the required gear.
„ The spindle speed can be adjusted using the SPEED +/- soft keys.
Mill Spindle Program Run
Mill Spindle can be used within a program for any program step that
has a mill spindle tool defined for that step.
When in program run, if the SPINDLE: Direction, and Speed fields are
defined for the tool, the operator can use the LEFT, or RIGHT ARROW
keys to display the Spindle control soft keys. When these fields have
not been defined, the Spindle control soft keys are not available.
To go back to the program control screen from the mill spindle control,
press the LEFT, or RIGHT ARROW keys.
The speed of the mill spindle can also be adjusted while in the program
control screen by pressing the SPEED +/- soft keys.