ADS-TEC OPC5012 - Manual (Page 12)

Industrial PCs OPC5012
12
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
4 S
TARTUP
Warning:
The PC should be switched off before disconnecting plugs in order to avoid damage to
electronic components!
In order to avoid formation of condensation, the device should only be switched on once
it has acclimated to the room temperature.
Pay attention to the voltage permitted for the device.
You should allow five seconds to pass between switching the device off and switching it
back on.
4.1 A VAILABLE INTERFACES
The devices have the following interfaces as standard:
Note:
Cable shielding of a data cable has to be connected to the plug connection casing (EMC).
The interfaces have to be enabled in the embedded operating system and the matching
drivers have to be installed to be able to use the interfaces.