AiM LCU-One CAN for MXL QM/EVO3 QM - Manual (Page 12)

LCU-ONE CAN connected to MXL QM and EVO3 QM
User Manual
Release 1.04
1 5
4.3 – System configuration
System configuration is the most important operation to make in order to correctly sample
data and show them on the logger display (if available). This layer layout depends on the
logger to be configured: activate “System configuration layer” and fill in the window.
1 6
4.3.1 – Configuring MXL QM
RPM box
:
If the info comes from a sensor installed on
the vehicle, press “AIM sensor”: ‘multiply
factor’ case enables: insert the proper
multiply factor and RPM max value.
In case this info comes from the vehicle
ECU, insert only RPM Max value.
Moreover it is possible to link an alarm led
to an over-rev threshold value to be
inserted in the related case.
Gear sensor box:
The engaged gear number can be sampled
and shown or not (In this case press “None”
button). As shown here on the right the
information can come from a gear
potentiometer installed on the vehicle, from
the ECU or can be calculated through an
algorithm based on RPM and speed. Press
the button corresponding to the vehicle
situation and insert highest gear number if
required.
www.aim-sportline.com
11