AiM GET Power ECU for SoloDL - Manual (Page 4)

3
In case GET ECU is already connected to an external device it is possible to maintain this connection
using AiM cable. As explained in the drawing below, GET ECU can be connected to AiM cable male
connector labelled “To the ECU” and the third device can be connected to the ECU through AiM cable
female connector labelled “To other devices”.
ECU connector has a cap on it. If nothing else is connected to the ECU remove the cap and place it on
AiM cable female connector (labelled “to other devices” here above) and connect AiM cable male
connector to the ECU female connector.