AiM Microtec M222 for SoloDL - Manual (Page 4)

3
In case Microtec ECU is already connected to an external device it is possible to maintain this
connection using AiM cable. As explained in the drawing below, M222 ECU can be connected to AiM
cable male connector labelled “To the ECU” and the third device can be connected to the ECU through
AiM cable female connector labelled “To other devices”.
ECU connector has a cap on it. If the ECU is only connected to SoloDL remove the cap and place it on
AiM cable female connector (labelled “to other devices” here above) and connect AiM cable male
connector to the ECU female connector.
2
ECU Software setup
Before connection to SoloDL, Microtec ECU needs to be setup via MON software. ECU channel
frequency is to be set on 50 or 100Hz value. Please refer to MON software user guide to know how to
perform this operation. As an example we are showing here below channel frequency setting page of
MON172 software.