AirLive WFP-101U v2 - Manual (Page 53)

45 AirLive WFP-101U v2 User’s Manual
Tip: Before you upgrade the firmware, please make sure that the IP Address
settings of the MFP server are in the same network as your computer.
Load Default: If you want to reset the MFP server to default factory settings,
please click “Load Default”.
Wireless Function: You can select “Auto”, Enable” or “Disable” to manually
configure the wireless function.
Auto – “Auto” is the default setting of the MFP server. At this mode, the MFP
server will automatically decide to enable or disable the wireless function.
When the MFP server starts up, it will auto-detect if the LAN port is connected
to an active network by an Ethernet cable. If this is the case, the MFP server
will run in Ethernet mode. If the MFP server is not connected to an active
network by Ethernet cable, the MFP server will run in wireless LAN mode.
Users can plug the Ethernet cable into the MFP server, after configuring the
MFP server features and wireless settings; they can unplug the Ethernet cable
to enable the wireless connection. This makes the configuration much easier
without creating the wireless connection in advance.
Note: After you have set the wireless function, please remove the Ethernet
cable and then re-plug the power jack of the MFP server to activate the
wireless connection.
Enable – Enable wireless function only; the MFP server’s wireless LAN will be
enabled and Ethernet will be disabled.
Disable – Disable the wireless function, the MFP server’s wireless LAN will be
disabled and Ethernet will be enabled.
Domain Country: The wireless channels are different from country to country.
Generally, the channels are from 1 to 11 in the USA and from 1 to 13 in Europe.
The operating channel will be set to the MFP server before importing. If you
are in different a country, please make sure that you have set the available
channels according to your location.