Aladdin Light Lift ALL200RM-CM - Manual (Page 15)

STEP 26
Run controller wire in to single gang box for Keyswtich Controller or optional SmartLift Controller.
Chandelier must be visible from controller location.
STEP 27
If using a Keyswitch Controller instead of a SmartLift Controller, secure key cylinder to cover plate using
supplied keyswitch nut.
Plug controller to controller wire. Use supplied cover plate screws to attach controller to single gang box.
STEP 28
Test motor and automatic shut-off system of ALL200RM. For operation instruction, reference Keyswitch
Controller Guide or SmartLift Controller Guide, then follow below:
Operate ALL200RM down a few inches. Operate ALL200RM up to CEILING POSITION. When
ALL200RM pulls bottom contact plate and temporary weight to the CEILING POSITION, the motor
will, if installed and adjusted properly, shut off by itself.
Call Aladdin Light Lift (877) 287-4601 if ALL200RM does not shut off at CEILING POSITION.
Never extend the full length of winch cable from the ALL200RM. This could cause the cable to become
reverse wrapped on the winch. An ALL200RM installed with a reverse wrapped cable can cause the
chandelier to fall, which could cause death, personal injury, and/or property damage. Refer to the
Keyswitch or SmartLift Controller tag for correct operating instructions. Winch cable length can be
found on the ALL200RM product sticker, shipping box, and on the front page of these installation
instructions.
STEP 29
Operate ALL200RM to the DOWN POSITION. Temporary weight should be at desired elevation to
install chandelier.
STEP 30
Holding tension on winch cable, unscrew temporary weight from fixture coupler.
Never operate the ALL200RM without tension on the cable. This could cause the cable to wind off the
winch drum and get damaged. A damaged cable could cause the chandelier to fall, which could cause
death, personal injury, and/or property damage.