Bradley Brand Furniture COMBI5500 - Manual (Page 2)

COMBI5500 Installation
2 9/30/08 Bradley Corporation • 215-329 Rev. K; EN 08-703
Supplies Required:
• 1" NPT supply piping to flush valve
• Toilet/Lav waste connections
• For optional air valve manifold: 1/2" NPT supply piping. Refer to Bradley Installation Manual (215-1158) provided with assembly.
• For optional self-closing valve: 1/2" NPT supply piping. Refer to Bradley Installation Manual (215-581) provided with assembly.
• For optional TouchTime ® solenoid valve: 1/8" NPT supply piping; wire nuts sized for 22 AWG to connect to 24 VAC power source.
Refer to Bradley Installation Manual (215-1378) provided with assembly.
Roughing-In Supplies, Drain, and Waste Outlet
7-1/2"
(190)
4" (102)
Square Hole
8" (203)
Square
Hole
3" x 5"
(76 x 127)
Hole
Threaded
Studs (6)
Lav Waste
Flush Valve
Supply
Toilet
Waste
34-1/2"
(876)
23-3/4"
(603)
15" (381)
Top of
Integral
Seat
11-1/4"
(286)
14"
(356)
7"
(178)
7-3/4"
(197)
4-1/2" (190) 4" (102)
31-1/2"
(800)
Finished Floor
Finished Floor
20"
(508)
22"
(538)
31"
(787)
7/8" (22)
Dia. Holes [5]
15"
(381)
15"
(381)
2" X 15" (51 x 381)
Valve Mounting Hole
(mm)
Single Opening in Wall* Multiple Openings in Wall
Top of integral seat is to be mounted 15" ( 381 mm)
above fi nished fl oor.
On fl oor outlet waste units, centerline of
waste is 4-1/4" (108mm) from wall.
All views are from the fi xture side
(right-hand unit shown).
Rough-in 1-1/4" or 1-1/2" NPT (size dependent
on options ordered) lavatory waste outlet at the
dimensions shown below. Use single or multiple
openings, depending on site requirements.
*Recommended when using optional wall sleeve