Bradley Brand Furniture COMBI5500 - Manual (Page 3)

Installation COMBI5500
Bradley Corporation • 215-329 Rev. K; EN 08-703 9/30/08 3
Five-Sided Unit Dimensions
17"
(432)
4-1/4"
(108)
18"
(457)
14"
(356)
Top View
23-1/2"
(597)
17"
(432)
19-11/16"
(500)
16-1/2"
(418)
14"
(356)
18"
(457)
23-3/8"
(721)
12-1/4"
(311) 4-1/4"
(108)
Floor
Waste
Option
COMBI55000 Series
(Center Confi guration)
COMBI55000 Series
(Angle Confi guration)
All fasteners must be securely
tightened to approximately 30 ft./lbs.
When fi nished, turn on the water supplies and check for
leaks and adequate water fl ow. Activate lavatory pushbuttons
and fl ush valve several times to purge air from the lines.
A
Insert six 1/2"-13 threaded studs (supplied by
installer) into the back of the unit and screw in
approximately 1/2".
B
Connect the flush valve supply pipe, lav waste,
and toilet waste (supplied by installer) to the
couplings located on the back of the fixture.
C
Sliding studs and pipes through the wall openings,
position the fixture in place (top of integral toilet seat
is 15" above finished floor). Mount Valve Asembly.
D Secure the fixture to the wall using anchor
brackets, washers, and nuts provided.
Valve
Mounting
Plate
(159-292)
Mounting
Channel
(140-558)
Washer
(140-002AM)
Nut
(110-119)
1/2" -13 Threaded Stud
0" - 4" Wall (109-039)
4" - 8" Wall (109-040)
8" - 12" Wall (109-048)
1
Install Unit
Side View
32-1/2"
(826)
15"
(381)
3-1/8" (79)
Wall-Mounted
Units Only
3-1/2"
(89)
3-1/2"
(89)
32-1/2"
(826)
15"
(381)
3-1/8" (79)
Wall-Mounted
Units Only
Floor
Waste
Option
12-1/4"
(311)