Allen&Heath ML3000 USER GUIDE - Manual (Page 2)

2 ML3000 User Guide
ML3000 User Guide AP4512 Issue 3
Copyright © 2005 Allen & Heath Limited. All rights reserved
This product complies with the European Electromagnetic
Compatibility directives 89/336/EEC & 92/31/EEC and the
European Low Voltage Directives 73/23/EEC & 93/68/EEC.
This product has been tested to EN55103 Parts 1 & 2 1996 for use in Environments
E1, E2, E3, and E4 to demonstrate compliance with the protection requirements in the
European EMC directive 89/336/EEC. During some tests the specified performance
figures of the product were affected. This is considered permissible and the product
has been passed as acceptable for its intended use.
Allen & Heath has a strict policy of ensuring all products are tested to the latest safety
and EMC standards. Customers requiring more information about EMC and safety
issues can contact Allen & Heath.
NOTE: Any changes or modifications to the console not approved by Allen & Heath
could void the compliance of the console and therefore the users authority to operate it.
Manufactured in the United Kingdom by Allen & Heath Limited
Kernick Industrial Estate, Penryn, Cornwall, TR10 9LU, UK
http://www.allen-heath.com
Limited One Year Warranty
This product has been manufactured in the UK by ALLEN & HEATH and is warranted to be
free from defects in materials or workmanship for a period of one year from the date of
purchase by the original owner.
To ensure a high level of performance and reliability for which this equipment has been
designed and manufactured, read this User Guide before operating.
In the event of a failure, notify and return the defective unit to ALLEN & HEATH or its
authorised agent as soon as possible for repair under warranty subject to the following
conditions :
1. The equipment has been installed and operated in accordance with the instructions in
this User Guide
2. The equipment has not been subject to misuse either intended or accidental, neglect, or
alteration other than as described in the User Guide or Service Manual, or approved by
ALLEN & HEATH.
3. Any necessary adjustment, alteration or repair has been carried out by ALLEN &
HEATH or its authorised agent.
4. The defective unit is to be returned carriage prepaid to ALLEN & HEATH or its
authorised agent with proof of purchase.
5. Units returned should be packed to avoid transit damage.
In certain territories the terms may vary. Check with your ALLEN & HEATH agent for any
additional warranty which may apply.