Allen&Heath ML3000 USER GUIDE - Manual (Page 24)

24 ML3000 User Guide
MAIN MIX and INPUT FADERS
This section applies to both the mono and stereo
channels.
MAIN MIX. A single switch routes the channel
signal to the 3 output main mix. Its balance and
image within the L, R and C outputs is determined
by the BLEND and PAN controls.
BLEND. Adjusts the balance between the LR and
C outputs. Fully anti-clockwise all the signal routes
to the LR outputs and none to C. At the detented
centre position the signal routes equally to the LR
and C outputs. Fully clockwise all signal routes to
the C output and none to LR. The control has a
3dB attenuation at centre position.
BLEND does not affect the group routing.
The stereo channels route stereo to LR and sum
the signal in mono to C.
PAN. Adjusts the balance between the L and R
outputs. It does not affect the C output. At the
detented centre position the signal routes equally to
L and R. PAN and BLEND combine to adjust the
balance between the 3 outputs.
PAN affects the group routing. It adjusts the
balance between odd and even groups 1-2 and 3-4.
The control has a 3dB attenuation at centre
position.
PAN adjusts the relative level of the left and right
signals of the stereo channels.
MUTE. This momentary action switch turns the
signal on or off, illuminating when the channel is
muted. Both the pre and post-fade signals are
affected unless the pre-fade pre-mute setting has
been internally configured. The channel can also
be muted by the mute groups, VCA group mutes,
snapshot memories (externally controlled) and MIDI
note on/off messages.
The switch also functions as an edit key when
assigning groups or the MIDI channel. In this case
the assign status is displayed on the GROUP
ASSIGNED indicator next to the fader.
The channel mute status is always displayed on the
switch regardless of mode.
PK
SIG
+6
0
ASSIGNED
GROUP
OO
30
5
0
10
5
40
10
20
PFL
3-4
GROUP ASSIGN
L
MUTE
R
PAN
LR
=
LCR
BLEND
= +
1-2
C
MAIN
MIX