Allen&Heath GLD-80 - Manual (Page 26)

GLD User Guide 26 AP8561 iss.4
Working with the Mix on the fader strips
Press a Main Mix master strip Mix key.
This is the normal mixing mode. The Input strips
present the channel faders. The Master strips
present the master mix faders.
Hold down the Assign key and press channel
Mix keys to assign or de-assign them from the
main mix. Current ON status is displayed on the
lower part of the strip LCDs.
Mix
Aux3
Mix
IP 1 IP 2 IP 3 IP 4 IP 5 IP 6 IP 7 IP 8 Aux1 Aux2 LR
Channel faders Master faders
+ press Mix
ON
Normal mix mode (FOH)
Assign Routing 
Main Mix active
hold
down
Press a Mix master strip Mix key.
Use this to work with Aux and FX sends. The
Input strips change to present all the send levels
to the selected mix. The Master strips present
the master mix faders.
Hold down the Assign key and press channel
Mix keys to assign or de-assign them from the
selected mix.
Hold down the Pre/Post key and press channel
Sel keys to toggle each source pre or post fader.
Current PRE status is displayed on the lower part
of the channel strip LCDs.
You can quickly set all assignments on or off, or
all sources pre or post fader by pressing the
Master strip
Mix or Sel key instead of a channel
key as described above.
All sends to one master Master faders
Aux3
Sel
Mix
IP 1 IP 2 IP 3 IP 4 IP 5 IP 6 IP 7 IP 8 Aux1 Aux2
+ press Mix Assign Routing
ON
all
+ press Sel Pre/Post
PRE
Master Mix

 all
Aux4
view Access Aux, FX, Matrix mix on faders
hold
down
Press an Input Channel strip Mix key.
Use this to work with Aux and FX sends. The Input
strips remain as Channel Faders. The Master
strips change to present all sends from the
selected channel.
Hold down the Assign key and press master Mix
keys to assign or de-assign the channel from each
mix.
Hold down the Pre/Post key and press master Sel
keys to toggle the channel pre or post fader to each
mix. Current status is displayed on the master strip
LCDs.
IP 6 IP 7 IP 8 Aux1 Aux2
ON PRE
Channel faders
Aux3
Sel
Mix
Channel Mix
Assign Routing
Pre/Post 

Aux4
All sends from one input
view
IP 5 IP 4
hold
down
Press a Group Master strip Mix key.
Use this to assign channels to the Audio and DCA
groups. The Input and Master faders are not
affected.
Hold down the Assign key and press channel Mix
keys to assign or de-assign the channels from the
group.
IP 4 IP 5 IP 6 IP 7 IP 8 Grp1 Grp2
+ press Mix all
DCA
Mix
DCA and Audio Group assign
Assign
DCA2

ON
DCA
1
hold
down