Module options - system – Allen&Heath iDR10 User Manual
Page 16
16
iDR10 User Guide
Module options - System
CPU module
Provides the control interface to the MixRack. This
module is identified as the ‘iDR RACK CPU’. It is not
interchangeable with the iLive Surface CPU module.
Power ON Blue LEDs display the power supply
status. One or two power supply modules may be
fitted to the MixRack. The second provides dual
supply redundancy.
12V LAMP Plug in a standard 4-pin XLR gooseneck
console lamp to illuminate the rack while plugging
up in a dark environment. We recommend you use
the Allen & Heath LEDlamp with long life white LED
bulbs and built-in dimmer.
NETWORK A 3 port Ethernet switch is built in. This
lets you connect several network devices to the
iDR10, for example an iLive Surface and a laptop
running the iLive application software. The yellow
Lnk/Act indicators flash to indicate network data
activity.
Note:
Do not connect more than one network cable
between two devices. Attempting to connect a
second cable as a ‘redundant backup’ will result in
loss of control.
Note:
When using firmware versions up to V1.2,
disconnection of the network cable or loss of
network connection requires a Surface reboot.
Reset A recessed switch lets you reset the network
address and settings to factory default. This is useful
if you are using a MixRack and a Surface with
unknown network addresses or which had different
addresses previously set. Resetting each networked
device (MixRack, Surface and TouchScreen) will
ensure the devices connect correctly. To reset the
settings, press and hold the switch in using a
pointed object while powering up the rack. Keep the
switch pressed for at least 10 seconds while the rack
boots. Default settings are:
IP address 192.168.1.1
Subnet mask 255.255.255.0
Gateway 192.168.1.254
MIDI IN, THRU and OUT - Standard MIDI interface
for external system control using MIDI messages.
For more information refer to the iLive Reference
Guide and firmware version release notes.
PL-Anet - Proprietary RS485 based control port for
connecting Allen & Heath PL Series remote
controllers such as wall plates, GPIO and
fader/encoder panels. For more information refer to
the iLive Reference Guide, PL Series guides and
firmware release notes.