Altman Lighting Track Lighting: GLOBALtrac tec 2-circuit / 2-neutral track system - Manual (Page 5)

FEEDING TRACK AT A CORNER CONNECTOR
INSTALLING CONNECTORS
1.
Select the correct connector to fit the end of the track.
2.
Align the guide lug of the connector with the groove on the
track.
3. Insert the connector into the end of the track, ensuring that
the guide lug enters the groove in the base of the track.
4.
If the connection is too tight, loosen the lock screw until the
connector slides in.
5.
Once the connector is correctly inserted, tighten the lock
screw.
GLOBAL tek track can be fed at the following corners and track intercept connectors
When feeding at one of the above connectors, follow the feeding instructions as shown
under ‘INSTALLATION OF GLOBAL TEK TRACK TO AN OUTLET BOX’.
NOTE: The track is polarized, so connectors can only be installed in the track in one
direction. I, L, T, X-connectors are pre-wired, and should not be re-configured in the
field. When requiring a turn in a different direction, or if an opposite T-connector is
required,remove the cover and turn the connector as shown above.
Bent TEK 34
L-connector
TEK 39 T-connector
TEK 40 T-connector
34 L-connector
Bent TEK 39 T-connector
NOTE: Dark line
directs polarity
ridge on track.
TEK 38 X-connector
TEK
Bent TEK 40
T-connector
TEK 14 Middle feed
TEK 21 Straight connector