Anchor PZ (PARTY) SERIES - PROFILE SIZE: 94MM X 48MM ADDENDUM - HIGH PEAK - Manual (Page 3)

3
Raise all arches, connect all cables and adjust and secure all members as
indicated in the standard PZ installation manual.
Do not yet tighten Cross Cable until after installation of Fabric and High
Peak Attachment.
Begin Fabric Installation with the High Peak Bays. Pull in as noted on the
standard PZ installation manual. See Figure 4a.
After fabric is pulled in, secure with Cam Buckle Strap at the end of each
rafter as shown in Figure 4b (6 places for each High Peak Mid). Pull
D-ring on strap until fabric is secured.
Using a Step Ladder, Install High Peak Attachment to top of High Peak
Arch. Install as illustrated in Figure 5a. A second installer may be required
to help maneuver fabric as the High Peak Attachment is installed.
Place the Dished Boiler Head with support Pipe over the Spindle. Turn
the Spindle nut until Fabric is properly tensioned over the Dished Boiler
Head. Adjust Fabric as the High Peak Attachment is being raised so that
it is straight on the frame. Red Marking on Spinidle should NOT be visible
on spindle when Dished Boiler Head with Support Pipe is in final raised
position.
Now, using the turbuckle, tension the cross cable on the High Peak Arch
so that High Peak Arch does not move out of square. It may be necessary
to adjust tension on the cross cable as the Dished Boiler Head is being
raised.
4
5
Eyebolts - use in place of
the standard bolts where
required.
3
Figure 4a
Figure 3a
High Peak Bays
High Peak Fabric
Cross Cable
High Peak Arch
Kedar
Cam Buckle
Rafter
Strap for keeping fabric in
place while high peak is being
installed and until fabric can be
tensioned down.
Pull Rope
High
Peak
Fabric
Figure 4b
Red Marking
Dished Boiler
Head with
support pipe.
16mm x 120mm
Threaded bolts &
Nuts
Spindle Nut
Spindle Base
Plate
Mounting Plate
Spindle
Figure 5a
Lubricant must be applied
to spindle prior to installa-
tion or removal of High Peak
Attachment.
High Peak
Attachment