Anchor NAVI-TRAC 30 WIDE HIP-END - Manual (Page 19)

19
Wall Installation
Step 1
Determine which side of wall is inside
and out. Ground bar pockets are on
outside, Lace flap is on inside. Start by
feeding top of kedar edge into channel
opening until top of wall is as far as it
will go. (Figure A)
Insert the bottom edge of kedar into
channel opening and feed down until
wall is smoothly installed into upright.
Step 2
Starting with wall tab nearest the lace,
insert into slotted opening in bottom
channel of eave bar. Feed rest of wall
tabs into channel.
Step 3
Repeat with the matching half of the
wall.
Step 4
Lace wall starting at top of wall bring-
ing top loop thru the top grommet of
matching half of wall to inside of wall.
Continue with this process looping next
loop thru grommet and then the up-
per loop until all loops are laced. (See
Figure B) Tie off bottom loop to keep
lace together.
Step 5
Slide ground bar (Figure C) thru pocket
on outside of wall. Fasten to frame us-
ing the ground bar keeper as noted on
next page.
Outside View
Channel
opening Channel
opening
Inside View
Eave Bar
Lace
Flap
Eave Bar
Velcro for
lace flap
Lace loops thru
grommets
Wall tabs
Ground bar
pocket
Ground bar
Figure A
Figure B
Figure C