Center pole top weldment & pole cap, Lacing (cont’d) 4 – Anchor CENTURY 100 & 120 WIDE User Manual
Page 10
10
Set top weldment in center pole hole and connect to over-
lapping rings as shown.
Place pole cap over top weldment, and push fabric and
weldment up into cap and secure from underneath by
threading the female coupling onto the male pipe fi tting
molded to the inside top of the pole cap.
Center Pole Top Weldment & Pole cap
Overlapping
Rings
Top Weld-
ment
Female
Coupling
Top Weldment with
Female coupling on
top.
Molded Cap with
male threaded pipe
fi tting
Continue lacing process. Attach ridge snap to ring as
you come to them. (100’ wide tents only)
Tie off last long loop. Cover lacing by joining protective
fl aps using Maxi Grip tool.
Secure fl ap with buckles at top and bottom. Then lace
from center pole to eave on both sides of tent. Tie off
last long loop. Align plates and attach hook on inside of
tent as shown.
Attach two guy webs through both plates.
Lace all sections of tent.
Lacing (cont’d)
4