Aquascape MicroPond & MicroPondless Kits (99763, 99764, 99765 & 99769) - Manual (Page 13)

13
Plug in and tweak the waterfalls
• As soon as the MicroPondless ®
or MicroPond ® is filled and all
of the black waterfall foam is
dry (if used on project), you
may plug the pump in and test
the waterfall.
• You can tweak the waterfall by
placing smaller stones and gravel
on the waterfall cascades. This
will change the appearance and
sound of the water. Have fun
playing with the water coming
over the falls until you achieve the
desired effect.
Trim the liner
• With everything running, go
around the perimeter of the
pond with a pair of scissors and
trim off any excess liner, always
leaving several inches above the
water level as a precaution. The
remaining liner edges can be
covered with gravel.
Note: Do not trim the liner until the
waterfall is running and the pond
is filled to the desired level.
Prematurely trimming the liner
may cause leaks!
Mulch the berm
• The entire area surrounding the
basin can now be mulched and
any surrounding plants added.
Clean up
• You’re at the final stages of the
project! All that is needed now is
to clean up the mess you’ve made
around the yard.
STEP 15 PD/PL
STEP 16 PD/PL
STEP 17 PD/PL STEP 18 PD/PL