Artograph MC250 - Manual (Page 2)

Mounting Surface/Projection
Area
To minimize distortion of the projected
image, the MC 250 must be mounted
upon a hard, fl at level surface so that the
projector is pointed perpendicular to the
projection area. The height of the surface
will depend upon the image size and where
the image needs to be projected. The MC
250 is equipped with adjustable front legs.
These should only be used when viewing
an image and not tracing, unless distortion
is desired. When the front legs are
extended and the projector is tilted up, the
image will become distorted (keystoned).
Thank You...
for purchasing an Artograph MC 250 projector. This projector has been designed with superb optics
and projection characteristics, producing outstanding image quality and accuracy. The MC 250 will
enlarge any image from photos to complex designs in full color and with infi nite detail. Use it to view
or trace photos and designs onto a wall, canvas or any vertical surface with outstanding results.
As with any precision equipment, treat it with care and it will provide you with years of excellent
performance. Should you need additional information or help with your projector, please contact
your local dealer or Artograph, Inc.
SAVE THESE INSTRUCTIONS
UNPACKING
Upon removing the MC 250 from its packaging, check it over carefully for any hidden
damage. IF DAMAGE IS FOUND, do not proceed until damage is reported to and
inspected by the freight carrier or your place of purchase.
QUICK SETUP
1. Mount projector onto a fl at surface. Plug in power cord into a 110v receptacle and
turn on switch. (Fig. 1)
2. Lay copy face down onto glass copy area. Close cover. (Fig. 2)
3. Adjust distance to projection area to achieve desired image size and rotate lens to
focus. (Fig. 8)
Please read this entire operation manual
before operating the unit. Refer to the
corresponding pictures to the instructions
below.
Projection Room
For best results the projector should be
used in a room where the lights can be
turned completely off and no window light
is present. The projector works similar to
a fl ashlight, so the darker the room, the
brighter and clearer the image will become.
To achieve maximum enlargement of 15
times, a minimum distance of 15 feet
is required. A 110v electrical receptacle
should be near by.
DETAILED OPERATION