Artograph Prism Table Stand (225-206) - Manual (Page 3)

through the stand bracket hole as
shown. Projector copy board cover
should be facing forward or away
from the stand (Fig. C).
Tilt projector’s back toward the
back plate until ears of the lock are
inserted into the slots in the back of
the projector. While holding projector
against back plate, turn the locking
knob counter clockwise as indicated in
Fig. D, to lock the projector in place.
Plug the cord into a nearby electrical
receptacle making sure the cord is not
in the way.
4. Install Lens - Fig. E
PRISM PROJECTOR: Use the
standard lens that came with your
Prism projector. SUPER PRISM
PROJECTOR: Use the accessory
lens that was included with your Super
Prism (the lens without the protruding
focusing ring). If your Super Prism did
not include an accessory lens, please
see notice at beginning of manual.
Install lens by sliding it into the lens
barrel. Position the lens for enlargement
or reduction as shown in Fig. E.
PLEASE NOTE:
There is a rubber ring attached to the
end of the lens which is designed to
prevent the lens from entering the lens
barrel too far into the projector, making
it diffi cult to remove. When reversing
the lens, simply roll the ring down to the
opposite end until it sits in the groove.
Fig. C
•
Top of
Projector
(Copy Board Cover)
• Ears
• Lens Cone
• Bracket
Hole
Fig. D
• Locking
Knob
Lens Cone •
Fig. E
Enlargement
Position
2 1/4x - 3x
Reduction
Position
4/5x - 1 3/5x
3