Bakers Pride BPSB Manual - Manual (Page 2)

TABLE OF CONTENTS
Installation Instructions .............................................................................................................................2
Operating Instructions...............................................................................................................................3
Maintenance Instructions ..........................................................................................................................5
Warranty ..................................................................................................................................................7
INSTALLATION INSTRUCTIONS
• Installation of the equipment should be performed by qualified, certified, and authorized personnel
who are familiar and experienced with local installation codes.
• Before Installation please read instructions completely and carefully.
• Do not remove permanently affixed labels, warnings or plates from the product.
SHIPPING DAMAGE CLAIM PROCEDURE
The equipment is inspected & crated carefully by skilled personnel before leaving our factory. The
transportation company assumes full responsibility for safe delivery upon acceptance of this
equipment. If shipment arrives damaged:-
1. Visible loss or damage: Note on freight bill or express delivery and signed by person making
delivery.
2. File claim for damages immediately: Regardless of extent of damages.
3. Concealed loss or damage: If damage is noticed after unpacking, notify Transportation
Company immediately and file 'Concealed Damage' claim with the transportation carrier. This
should be done within fifteen (15) days from the date delivery and receipt of goods. Retain
container for inspection.
• Please observe all local and national codes and ordnances
• Installation must conform with local codes, or in the absence of local codes, the National Fuel Gas
Code, ANS1 Z223.1 (latest edition) In Canada, installation should conform to installation codes for
gas burning appliances and equipment standard CAN/CGA-B149.1 or the Propane installation
code, CAN/CGA-B149.2, as applicable.
• Electrical wiring to the appliance must be electrically grounded in accordance with local codes or in
the absence of local codes with the National Electrical Code ANSI/NFPA 70, or the Canadian
Electrical Code, CSA C22.2, as applicable.
• A manual gas shut-off valve must be installed in the gas supply line ahead of the appliance and gas
pressure regulator for safety and ease in servicing.
• The gas pressure regulator supplied must be installed on the appliance prior to connecting the
equipment to the gas line. Failure to install a regulator could be potentially hazardous and will void
the appliance warranty.
• The appliance and its individual shut off valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressures in excess of ½ psi (3.45kpa).
• The appliance must be Isolated from gas supply piping system, by closing its individual manual shut
off valve during any pressure testing of the gas supply piping system at test pressures equal to or
less than ½ psi (3.45kpa)
2