It4000-ab, Setup & assembly instructions, 9 of 28 – BAND-IT IT4000-AB 5/16 Band-Lok Tool User Manual
Page 9: 5/16” band-lok tool
Document # I17794 Rev D
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
9 of 28
IT4000-AB
5/16” Band-Lok
Tool
Setup &
Assembly
Instructions
Handle adjustment:
• Using 1/4” hex key (supplied), adjust
the Support Arm/Handle to
ergonomically match the operators
hand.
• Be sure not to adjust the Handle too far
outward (beyond interlocking legs) or
the handle will not function properly or
provide support to the operator.
Hanger Support Instructions:
1.
An aluminum hanger (accessory)
can be utilized for supporting the
tool.
2.
A hanger can be installed (as
shown) into the two threaded holes.
3.
Secure the hanger against the tool
body with the two supplied screws.
4.
A light application of vibratite is
already included on the screw’s
thread.
Hanger Mount