BAND-IT J05069 Heavy Duty Adapter - Manual (Page 2)

J05069
Heavy Duty Adapter
Document # P35387 rev. H
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
Page 2 of 2
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
Repair Parts
& Assembly
J050 Heavy Duty Adapter, Repair Parts List
Band-It
Part No.
Item # Description Qty.
J00587 1 Shear Hook (Design may vary) 1
J00987 2 Pin, Grooved 1
J05187
3 Pin, Grooved 2
Body 1
Socket Head Screw 2
J06787 6 Screw Block 1
J06887
Hex Nut 1
Jr. Adapter Screw 1
Knob 1
J93099
10 Screw, Special 2
11 Backing Plate 1
12 Cutter Blade 1
13 Hex Key, 3/16” (not shown) 1
J11985 14 Ratchet Wrench 1
7
4
5
8
9
J01387 15 Hex Key, 3/16” (not shown) 1
Notes:
To assist in removing threaded parts, apply heat to soften
locking compound.
When connecting item 9 (knob) or item 7 (nut) to item 8
(screw), clean threads (male and female) of foreign mat-
ter, then apply one drop of medium strength locking com-
pound (Loctite 242 or equivalent) onto male thread and
connect parts together.
Periodically check item 10 (screw) for tension. Loosened
screws may result in assembly breakage.
Operating Tip: Keep the bolts tight (8-14 ft-lbs.). A loose
bolt may cause cracking or premature wear of the cutter
blade and/or backing plate. This could result in improper
clamp tensioning, locking, and cutting.
Operating Tip: Keep the leading edges of the cutter blade
and backing plate free of metal shavings. Metal shavings
will result in clamp tail gouging during tensioning. Clean
and hone the leading edges by hand. Do not use
power tools. Honing should polish surfaces, not re-
move material.
14
7
2
1
4
6
See Exploded View
3
5
8
9
* J93099 Exploded View
10
11
12
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html
*NOTE: Replacement cutter
blade kit design may vary.