Barranca Diamond PF10 Power Feed Trim Saw - Manual (Page 14)

14
START UP (continued)
Check to ensure that the toggle power switch is in the MIDDLE/OFF position. Plug the power cord from the
motor into the power feed receptacle (fig 9) on the power feed box (located on the front of the saw). The power
cord from the power feed box should be attached to GFCI receptacle.
Fig 9. Motor cord attached to the power feed box receptacle
If an extension cord is used to attach to the PF10 Trim Saw, use an extension cord that is at least 14 gauge
wire and no longer than 25 feet.
To perform a power up test on the PF10, first disengage the vise clutch by turning the clutch handle to the 12
o’clock position (fig 10) and then move the rock vise to the front (operator’s) end of the saw table (fig 12).
Fig 10. Clutch handle in disengaged (12 o’clock) position Fig 11. Clutch handle in engaged (9 o’clock) position
PF10 START UP