Barranca Diamond PF10 Power Feed Trim Saw - Manual (Page 16)

16
SLAB SAWING MODE
To begin slabbing of rock material, turn the toggle switch to the MIDDLE/OFF position (fig 3) and secure the
material in the rock vise by opening the vise jaws wide enough to fit the material to be cut. Retighten the jaws
with the wing nut screws on the rock vise (fig 14). The vise should be positioned close to (but not touching) the
diamond blade by placing the clutch lever in the disengaged 12 o’clock position (fig 10) and moving the vise
forward toward the blade (fig 15).
Fig 14. Rock vise wing nut screws Fig 15. Material positioned in vise near blade prior to cutting
Once the vise is positioned close to the blade, loosen the wing nut on the front of the vise (fig 16) and laterally
move the vise to the desired slab thickness to be cut by turning the cross-feed handle (fig 17) clockwise or
counterclockwise. Retighten the wing nut on the vise.
Fig 16. Vise cross-feed locking wing nut Fig 17. Cross-feed handle
PF10 SLAB SAWING MODE