Battery Tender Junior 12V @ 0-75A (PN 021-0123) - Manual

DELTRAN BATTERY TENDER
®
JUNIOR
Installation & Mounting Instructions
________________________________________________________________________________________________________
Deltran Corporation, 801 International Speedway Blvd., DeLand, FL 32724 Page
1 of 2
Phone 386-736-7900 FAX 386-736-0379 www.batterytender.com
LIKE POLARITIES MUST CONNECT TO BE SAFE.
Covered Socket
is Positive
Quick Disconnect
same as used on
081-0069-6
Covered Socket
is Negative
Exposed Pin
is Positive
Battery Tender Junior
POS NEG
Ring Terminals: Approx
5/16" Inside Diameter
9/16" Outside Diameter Exposed Pin
is Negative
Battery
Automotive Style Blade Fuse
3.0 or 7.5 Amp
Fused Ring Terminals with
Quick Disconnect
PN 081-0069-6
The Battery Tender® Junior charger plugs directly into a residential AC receptacle. There no
AC power cord. There is no ON / OFF switch on the charger.
The DC output cord is a 2-wire, insulated cable assembly with a black, molded, 2 pin quick-
disconnect plug on the end. That plug connects to a number of DC output cable accessories.
The approximate DC output cable length is 10.5 feet. The UL-1236 Standard requires a total
of 12 feet from the AC mains wall receptacle to the battery terminals. The total cable
lengths are DC output cord 10.5 feet + DC Cable Assembly Accessory 1.5 feet (18 inches minimum).
The common DC output cable assembly accessories are: (Approx cable lengths 18 inch min, 24 inch
max.) Shown in order from left to right:
081-0069-6: Fused Ring Terminal Cable Assembly
081-0069-4: Fused Alligator Clip Cable Assembly
081-0069-5: Fused Cigarette Adapter Cable Assembly
Extension cables have the came cord configuration as the DC output cable connected to the charger
body. Each end of the cable extension has a black, molded, 2 pin quick-disconnect plug.
081-0148-25 Extension Cable, 25 ft long.
081-0148-12 Extension Cable, 12 ft long.
The following connection rule applies for DC cable assemblies and the black, molded, 2 pin quick-
disconnect plug.
If the DC cable is directly connected to the body of a charger, then the exposed pin is connected to
POSITIVE voltage at the charger output.
The same will be true for the exposed pin on the end of an
extension cable when the other end of the extension cable is connected to the charger DC output cable.
DC cable assembly accessories are designed so that the rings, clips, or the cigarette adapter connect to a
battery.
The exposed pin on a DC cable assembly accessory is connected to NEGATIVE OR
REFERENCE voltage at the battery. Again, the same will be true for the exposed pin on the end of an
extension cable when the other end of the extension cable is connected to a DC cable assembly accessory.