Bear Archery Compound Bow 2010 - Manual (Page 19)

19
INITIAL BOW SETUP
Before you can safely and effectively shoot your
bow, a number of specific initial bow setup steps
must be taken. These steps can be performed on
your own, if your level of expertise is adequate.
Or, your local Bear Archery dealer can help you.
Arrow Rest Installation & Setup
Arrow rests should be installed according to the
manufacturer’s specifications. The first
adjustment you need to perform is setting the
vertical height of your arrow rest. When properly
adjusted, your arrow rest should align the
centerline of the arrow with the center of the two
holes used to mount the rest to the riser. To
check this, place an arrow in the rest and nocked
on the string. Visually confirm the center of the
arrow passes directly through the center of the
arrow rest mounting holes when viewed from the
side. If not, adjust your rest up or down to
correct.
Next, the rest should be adjusted for proper
“Centershot”. With an arrow in the rest and
nocked on the string, firmly hold another arrow
against the inside of the riser near the arrow rest
mounting holes as illustrated. Look down the
arrows and verify that the arrows are parallel to
each other. In other words, the spacing between
the two arrows should be the same along the
entire length of the arrows. If not, adjust your
rest side to side to correct. This is only your
“initial” centershot and additional fine tuning
may be required depending on your shooting
style and equipment. Please refer to the images
on the next page for further reference.