Bear Archery F-Series Crossbow 2004 - Manual (Page 5)

Attach the Prod and Limb Assembly to
the Main Frame and Stock Assembly
1. Slide the Prod and Limb Assembly into place on
the Main Frame Assembly making sure the circular
portion of the Cable Saver aligns with the under
portion of the inner Main Frame. The string should
be resting on the Flight Deck. Figure 4A.
2. Secure the Prod and Limb Assembly to the crossbow
Main Frame Assembly with the single Prod and Limb
Assembly Mounting Screw & Washer provided. Make
sure that the Prod and Limb Assembly is tight to the
frame without play. Figure 4A. If there is any movement
between the Prod and Limb Assembly and the Main
Frame and Stock Assembly, stop the assembly of
your crossbow and call the Customer Service
Department at 1-866-556-2754.
To detach the Prod and Limb Assembly from the Main
Frame and Stock Assembly, reverse the steps above.
Install the Pin Sight (Model F-300)
1. Place the Front Sight along the Main Frame Rail
over the two holes towards the front end of the
Main Frame on the left side. The Front Sight
Bracket should angle towards the front of the
crossbow, as shown in the diagram. Figure 4B.
2. Secure the Front Sight Bracket to the Main Frame
using the two Front Sight Mounting Screws and
Front Sight Mounting Washers provided.
3. Install the Pin Sight to the Front Sight Bracket in the
slot furthest to the rear (the pin may be moved to
another slot later during the sighting-in process).
The Pin Sight should be installed so the Front Sight
Bracket is between the lock washer and the
tightening barrel. Figure 4C.
4. Attach the Rear Peep Sight to the dovetail mount
on the top of the Main Frame by sliding it on from
the rear. Figure 4D.
WARNING! MAKE SURE THAT THE STIRRUP IS
INSTALLED WITH THE NOTCHES TO THE UNDERSIDE
OF THE CROSSBOW. THE SCREWS THAT ARE
INSTALLED IN STEP 2 SHOULD TIGHTEN DOWN
THROUGH THE PROD AND LIMB ASSEMBLY AND
INTO THE NOTCHES. INSTALLING THE COCKING
STIRRUP IMPROPERLY COULD RESULT IN THE
STIRRUP DETACHING FROM THE CROSSBOW
DURING COCKING, AND MAY RESULT IN INJURY.
!
4
Figure 4A
Prod & Limb Assembly installation
Cable Saver
Figure 4B
Front Sight Bracket installation
Figure 4C
Pin Sight installation
Figure 4D
Rear Peep Sight installation