Wheel well installation, Beaver tail installation (optional), Figure 10 – Bedrug TRAILERWARE: TrailerWare Standard Kits User Manual
Page 4: Figure 8 figure 9
Wheel Well Installation
1. Measure and cut a section of TrailerWare material large
enough to cover the entire wheel well. Include an extra inch of
material at the floor for final trimming.
2. Starting on one end of the wheel well, apply adhesive to the
back, sides, and top of the wheel well. Be sure to apply the
spray adhesive to both the TrailerWare material and the wheel
well. Press firmly into place.
(FIGURE 8)
3. Cut a vertical slit on the front corners of the wheel well. It is
easiest to trim from the foam side and use the wheel as a
guide.
(FIGURE 9)
4. Apply adhesive to the inner surface of wheel well and
TrailerWare material. Press firmly into place. Use a wooden
block to press material firmly into the corners to create a tight
fit. Trim any excess material at the corners and floor.
(FIGURE 10)
Installation is now complete! Simply re-Install any
brackets, lights, shelving, etc. as required.
FIGURE 10
Not all trailers have a slope at the rear of the trailer, and
some may already have a diamond plate piece in place.
If not, TrailerWare creates a nice continuous look all the
way to the floor. Simply measure and cut triangular
pieces and apply adhesive to both the wall and backing
and press into place. Remember to match the material
grain to the wall for a seamless appearance.
Beaver Tail Installation (Optional)
FIGURE 8
FIGURE 9
LIMITED WARRANTY
TrailerWare warrants TrailerWare products to be free from defects in materials and workmanship. TrailerWare premium wall coverings will be warranted for the duration of the
trailer ownership by the original TrailerWare purchaser. The terms of this warranty may vary from state to state. You may have rights under specific state laws that differ from
the terms of this warranty. Proof of purchase will be required for warranty service. Customer modifications and/or improper installation of the product may void this warranty.
For warranty instructions and returns, contact TrailerWare Customer Service at 866-210-7457. Labor and shipping are not covered under the terms of this agreement.
Retain this warranty information with your vehicle owner’s manual for future reference. FOR WARRANTY SERVICE CALL 866-210-7457
TRAILERWARE WALL COVERING KITS – CLEANING GUIDE
TrailerWare Wall Covering is mildew resistant and will not absorb liquids. The engineered polypropylene fiber resists stains and deterioration from most acids, chemicals, gas,
oils, etc. Therefore, by following this cleaning guide, your TrailerWare should remain serviceable for as long as you own your trailer.
REMOVING DEBRIS: Use a vacuum, broom, brush or compressed air to remove dirt and/or grime. Water will not harm the TrailerWare material, so pressure washing is
also effective when necessary. Most acids will not harm TrailerWare wall covering. Apply baking soda immediately to neutralize the acid and prevent any damage to trailer
wall underneath.
Detergent soap with degreaser and water may be used to clean tougher jobs such as gasoline, oil, and chemicals. Detergent soap is readily available at most car wash locations
with pressure washing equipment. Rinse thoroughly. TrailerWare’s closed-cell foam will not absorb water, and the polypropylene fiber dries in minutes.
TWINST Rev. 1 1/26/2012
Page 4 of 4