User maintenance instructions, Care & cleaning instructions, Storing instructions – BELLA 13638 1 Liter Ice Cream Maker User Manual

Page 10

Advertising
background image

8

USER MAINTENANCE INSTRUCTIONS

This appliance requires little maintenance. It contains no user serviceable parts.
Do not try to repair it yourself. Any servicing that requires disassembly other than cleaning
must be performed by a qualified appliance repair technician.

CARE & CLEANING INSTRUCTIONS

CAUTION: Never immerse the motor housing, plug or cord in water or any other liquid.
1.

Always unplug the unit before cleaning.

2.

Unlock and remove the Ice Cream Maker lid following instructions outlined in the
“Operating Instructions” section of this Instruction Manual.

3.

Remove the motor housing from the lid following instructions outlined in the “Before Using
for the First Time” section of this Instruction Manual. (See Figure 2.)

4.

Whenever possible, rinse parts immediately after processing to make cleanup easier.

WARNING: To assure the maximum freezing performance of the freezer bowl, DO NOT
use scalding hot water to rinse or wash freezer bowl.

5.

Wash and rinse the freezer bowl, mixing paddle and lid in warm, soapy water. Dry using a
clean kitchen towel. Do not use paper towels as they will stick to the cold freezer bowl.

IMPORTANT: Do not place the freezer bowl or motor housing into the dishwasher. The
mixing paddle and clear plastic lid are top-rack dishwasher safe.

6.

If necessary, wipe the exterior surface of the freezer bowl and the motor housing with a
moist cloth or sponge and dry thoroughly.

7.

Never use rough scouring pads or abrasive cleansers on any plastic or metal parts as the
surface may be damaged.

STORING INSTRUCTIONS

1.

Make sure Ice Cream Maker is unplugged before storing.

2.

After using the ice cream maker, follow the CARE & CLEANING INSTRUCTIONS to
ensure the unit is properly clean.

3.

Store in original box or in a clean, dry place.

4.

Never place any stress on the power-supply cord, especially where the cord enters the
unit, as this could cause the cord to fray and break.

Advertising