BELLA 13638 1 Liter Ice Cream Maker - Manual (Page 7)

BEFORE USING FOR THE FIRST TIME
1. Carefully unpack the Ice Cream Maker and all parts. Your Ice Cream Maker will be
assembled; the mixing paddle will be packed inside the freezer bowl.
2. Remove the motor housing / cord from the lid. Rest the lid on a clean, flat surface.
Press the 2 release pins while pulling the lid up and off the motor. (See Figure 2.)
Set motor aside in a clean, dry area.
3. Wash the freezer bowl, mixing paddle and lid in warm soapy water. Rinse and dry
thoroughly.
CAUTION: To protect against risk of electrical shock, do not place motor housing,
plug or cord in water or any other liquid.
4. Wipe the motor housing with a moistened cloth. Dry thoroughly.
5. Replace the motor housing into the lid. An audible click can be heard as the motor locks
into position.
6. Press firmly until the mixing paddle locks into the center hole in the motor housing.
Set aside. (See Figure 2.) Set assembled lid aside.
7. Set your freezer to the coldest setting. Place clean, empty freezer bowl in an upright
position, towards the back wall of the freezer for at least 12 hours before processing
frozen desserts.
NOTE: Freezing the freezer bowl 25 hours prior to use will ensure the best possible results.
IMPORTANT: To ensure proper freezing ability of your Ice Cream Maker, before adding
mixture, make sure the empty freezer bowl has been stored in an upright position
in the freezer for at least 12 hours.
5
Figure 2
Paddle Lock
Release Pins