BLACKHAWK! SPECOPS NRS SHOTGUN STOCK - Manual (Page 2)

Page 1
www.BLACKHAWK.com
BLACKHAWK! ® NORFOLK, VA U.S.A. 1.800.694.5263
SpecOps NRS Installation Directions
ATTENTION: Read and follow all instructions and warnings prior to installation and/or fir-
ing a SpecOp NRS equipped shotgun.
Take extra time to review the shooting tips & tech-
niques section of this manual. If you are at all unsure of your ability to install your
SpecOps NRS stock safely, please seek the services of a competent gunsmith.
WARNING: Before beginning stock installation, make sure that the shotgun is UN-
LOADED. Carefully check the chamber and magazine tube making both visual and touch
verification.
NOTICE: The SpecOps NRS is not compatible with the FN "Tactical" Shotgun. Prior to in-
stalling a SpecOps NRS the "Tactical" trigger group must be replaced with a standard
Winchester 1300/FN Police trigger group. Contact Winchester or FN for replacement trig-
ger group.
TOOLS REQUIRED:
• Socket Wrench, Long Extension and Sockets
• Medium Phillips Screwdriver
• Large Flat Blade Screwdriver
• Extended “Ball End” Allen Wrench
Remington 3/16” (SAE) - Moss., Win., FN 1/4” (SAE)
upgraded Allen wrench is available from BLACKHAWK!
• Blue Loctite #242 (optional)
1. Remove original stock. Refer to manufacturer’s instructions for the best method to re-
move stock. Normally the pad is held in place by two Phillips screws and the stock is
held on by one bolt. Remove the pad by unscrewing the Phillips screws and remove the
stock bolt to free the stock from the shotgun. (Fig. 1) Remington owners: Remove any
metal spacers from the back of the receiver.
Fig. 1