BLACKHAWK! SPECOPS FOLDER SHOTGUN STOCK - Manual (Page 5)

www.BLACKHAWK.com
©BLACKHAWK! Products Group ™ NORFOLK, VA U.S.A. 1.800.694.5263
www.BLACKHAWK.com
©BLACKHAWK! Products Group ™ NORFOLK, VA U.S.A. 1.800.694.5263
SpecOps Folder Operational Information Sling Mounting Tips
Page 3 Page 4
To extend or fold the stock, grasp the wire frame stock near the pistol grip and squeeze
the two sides together. This will release the locks and allow the stock to rotate. DO NOT
FORCE THE STOCK OR DAMAGE MAY RESULT. (Fig. 4 & 5)
Forend Installation Instructions
If you ordered a replacement forend with your SpecOps Folder, refer to the installation
directions below. Refer to manufacturer’s instructions that came with your gun for the
best method to remove your forend. Shotguns generally have some type of retaining nut
that must be removed to free the barrel and another to free the forend. (Fig. 7)
1. Remove the barrel retention nut.
2. Remove barrel from action.
3. Remove forend nut by turning with appropriate tool.
4. Forend will now slide freely off and detach from slide handle.
5. Slide new forend back onto slide handle. Reassemble in reverse order
tightening the nuts according to the manufacturer’s recommendations.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Below is the recommended SpecOps Folder sling mounting location.
Figure 6: Attach sling by installing a
sling swivel into the stud or by running
nylon cord through the sling swivel stud.