BLITZ R-VIT DS - Manual (Page 15)

⑪Fuel Pressure setting: Only applicable to vehicle specified on the application list.
（１）Select Fuel Pressure from FUNCTION menu.
（２）Select CONTROL, then select ON to control fuel pressure, OFF to use normal setting.
（３）Select REVO to set the trigger RPM to startthe fuel pressure control.
（４）Select Press[%] to decrease/increase the fuel pressure from -9.9% to +25%.
（１） （４） （３） （２）
⑬Fan Control:Only applicable to vehicle specified on the application list.
（１）Select Fan Control from FUNCTION menu.
（２）Select Control, then select ON to control the fan, OFF to use normal setting.
（３）Select ON Temp, and select the switch-on temperature between 20 and 100 C.
（４）Select OFF Temp, and select the switch-off temperature between 20 and 100 C.
⑫Fuel injection control:Only applicable to vehicle specified on the application list.
（１）Select Fuel Injection from FUNCTION menu.
（２）Select Control, then select ON to control fuel injection, OFF to use normal setting.
（３）Select the desired rpm range from 0 to 3000rpm,(500 rpm per range),
and set the fuel injection decrease/increase value within ±25%.
Note: Depending on the vehicle type, this adjustmet effect can be absorbed by default feed-back loop control.
The result of this adjustment also reflects to Fuel Injection Trace under FUNCTION menu.
Change beyond engine capability can damage the engine.
Always ask professional to setup the active control.
Warning! Warning!
Warning! Warning!
To avoid Overcool/ Overheat, it is recommended to set ON temp from 90 to 95 C,
and OFF temp from 85 to 90 C.
Warning! Warning!
（１） （３） （２）
（１） （４） （３） （２）
Change beyond engine capability can damage the engine.
Always ask professional to setup the active control.
－ Initial Setup －
１４