Bos Deville 2014 User manual - Manual (Page 3)

Fitting your Idylle onto your bike demands care and attention.
For your safety, please do respect the following instructions.
1.1. the steerer tube
Before cutting the steerer tube, first you have to take some measurements : height of the headset, length of the
headtube of the frame, height of the stem and then add 5 to 10mm.
Calculate the lenght as below :
Add the length of the headtube of the frame to the height of the headset and to height of the headset plus 5 to
10mm.
1.2. INSTALLING THE FRONT WHEEL (20mm or 15mm axle)
To assemble the front wheel, check the following procedure
1. Open the quick release on right side of the fork (1).
2. Open the folding lever (2)
3. Unscrew the axle (3) and remove it
4. Install the wheel.
5. Insert the axle and screw it completely. Fold the lever. Close the quick release.
1.3. MONTING THE 15mm AXLE ADAPTATER SLEEVE
The transition from 20mm to 15mm axle requires the mounting of an adapter sleeve on the left side of the legs. To
assemble the adapter, proceed as follows:
1. ASSEMBLY
CAUTION
Never attempt to remove or replace the steerer or upper tubes independently from the crown. Modifying the
integrated crown, steerer, or upper tubes can cause an assembly failure, resulting in a loss of control of the
bicycle and serious injury.
– Screw by hand the 15mm adapter sleeve (1)
– Tighten up to the torque 12N.m
– Refer to the section 1.2 for the 15mm axle wheel mounting
(1)
IMPORTANT
The torque of the QR screws (A) is originally settled between 4 and 4,5 N.m. It may be useful to check it
regularly.