Bos Deville 2014 User manual - Manual (Page 5)

2.2. TRC OPTION (Deville 160 TRC only)
Setting on <ON> position, the TRC increases the stiffness of the fork by reducing the air chamber volume.
This system allows to keep the balance of the bike specially in downhill and to reduce the pedaling effects. In any
case, the fork fonction remains the same.
TRC <OFF> TRC <ON>
Lever position: forward Lever position: backward
Spring curve: standard Spring curve: ramping
Use: normal and climbing Use: downhill and pedaling
2.3. HYDRAULIC SETTINGS
Deville comes with 3 hydraulics adjustments: low speed compression, high speed compression, and rebound
IMPORTANT
Balancing the air chambers pressure
It is important to balance the positive and negative chambers to ensure optimum operation of the fork every time
you adjust the pressure.
Proceed as follows:
After adjusting the pressure, play the fork slowly 3-4 times on the first inch of travel.
Thus, the air pressure is distributed equally between the chambers, and your fork is ready to roll!
The low speed compression adjustment seats at the bottom of
the right hand leg with the silver knob (1).
The high speed compression adjustment seats at the bottom of
the right hand leg with the red knob (2).
The rebound adjustment is on the top of the right hand tube (3).
Always start from fully tighten position, then tighten down counting
the clicks to adjust your settings.
Tighten (anticlockwise) = close / harden
Undo (clockwise) = open / soften
You can adjust the position of the TRC lever in case it touches
your frame or for better handling.
Proceed as follows :
– remove the valve cap.
– Extract the lever.
– Replace it properly at the required position.
IMPORTANT
Air valve cap
TRC lever
(3)
(1)
(2)