CalDigit S2VR HD Manual - Manual (Page 16)

15
Important Note: You must delete your S2CR RAID set on the disk utility whenever you are configuring
your S2VR into a new setting. If you do not do this your system will still read the
old system memory which will cause false information on the disk utility.
Deleting your RAID set will erase your data.
Backing up your data on another S2VR HD is highly recommended.
You must restart your computer after every RAID setting change. We do not recommend frequently
changing your settings. If you are not sure about which RAID setting best suits your project, please use
the advanced mode on your S2VR manager
JBOD Mode
Your data will be lost as this process will reformat your drives.
Backing up your data on another S2VR HD is highly recommended.
Your S2VR HD comes pre-configured in JBOD mode and striped (Out of the box). If you have changed
your settings & you want to re-install the JBOD function, follow these steps.
Please delete your original S2VR’s RAID setting via Disk Utility (Under Raid Function)
Important Note: If your project is uncompressed HD 1080i you must use JBOD and striped.