Carter-Hoffmann CNH18LP - Manual (Page 5)

5
Countertop Mounting
Counter must be made of a non-combustible material, clean
and free of debris. Locate and drill four mounting holes in
counter top.
If desired, you may remove the legs from unit and secure to
counter top using threaded mounting holes previously occu-
pied by legs. Seal the perimeter of unit where it meets the
counter top with a food grade silicone sealant.
Drop-In Mounting
Counter-top must be made of
stainless steel, clean and free of
debris. Verify cut-out dimensions of
the counter-top. CNH12LP:
20.75”D x 24.25” W; CNH18LP:
20.75”D x 30.25” W.
Warmer is equipped with Carter-
Locks, uniquely designed turn-out tabs
which help to secure the top flange
of the warmer to the counter top.
Apply food-grade silicone sealant to
the underside of the warmer top
flange prior to setting the unit into the
cutout.
Set the warmer into the counter top
cut-out.
After installation, verify that the tabs
on the CarterLocks are turned out to
lock the warmer into the counter. A flathead screwdriver may
be used to turn the tabs.
Apply a thin bead of food-grade silicone sealant around the
flange to seal it to the counter.
INSTALLATION
GROUNDING INSTRUCTIONS
This appliance is equipped with a cord having a grounding wire with a
grounding plug which must be plugged into an outlet that is properly installed
and grounded. In the event of an electrical short circuit, grounding reduces
the risk of electric shock by providing an escape wire for the electric current.
WARNING—Improper use of the grounding can result in a risk of elec-
tric shock. Consult a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if doubt exists as to whether
the appliance is properly grounded.
The ground lug of this appliance must be connected to a suitable building
ground.
IMPORTANT:
Power cord is 6' long.
If necessary, contact a licensed
electrician to install an appropriate
20 amp electrical circuit with correct
NEMA receptacle. DO NOT use an
extension cord.
WARNING:
Risk of personal injury
Installation procedures must be
performed by a qualified technician
with full knowledge of all applicable
electrical codes.
Failure can result in personal injury
and property damage.
IMPORTANT:
NOT UNDER WARRANTY
Damage to unit due to be-
ing connected to the wrong voltage
or phase is NOT covered by war-
ranty.
CAUTION:
Risk of personal injury
Unit is not waterproof, to
avoid electrical shock keep unit and
counter from being submerged in
water. Do not operate if unit has
been submerged in water.
CAUTION:
Electrical Shock Hazard
The ground prong of the
power cord is part of a system de-
signed to protect you from electric
shock in the event of internal dam-
age.
DO NOT cut off the large round
ground prong or twist a blade to fit
an existing receptacle.
CAUTION:
To reduce the risk of fire,
the appliance is to be
mounted on surfaces of noncom-
bustible material only.
IMPORTANT: NOT UNDER WARRANTY
Damage caused by leaks due to improper installa-
tion is NOT covered by warranty
24.25” or 30.25” W
20.75”
D