Carter-Hoffmann PBH2S - Manual (Page 6)

ADJUSTMENTS FOR PLATES OR WAX BASES
The tension on the self-leveling carriage is adjustable for wax ba-
ses or plates, by connecting or disconnecting the tension springs.
As you are loading plates/bases, observe the plate level. The top
of the stack should be maintained at a comfortable height. If the
level is too high or too low, springs will have to be added or re-
moved to attain the desired height. To ensure smooth operation,
use a similar number of springs on all four sides of the tube. This
is done by connecting or disconnecting the springs from the bot-
tom retainer bracket. You will then have to set the switch(es) for
plates or bases.
TO ADJUST SPRINGS
1) Remove the dispenser assembly from the cabinet. Stand the assembly upright and secure it to
prevent tipping.
2) If you intend to hold bases, then make sure all 9 springs are attached as shown in Fig. 1.
3) If you intend to hold plates, detach 3 springs from the bottom bracket as shown in Fig. 2. and
allow them to dangle. They will remain out of the way, but available for later adjustments, if
needed.
4) Place 10 plates or 6 bases, depending on your spring settings onto the platform. The top base
or plate should be positioned at the top of the dispenser unit.
5) Once the proper adjustment has been achieved, remove the plates/bases and place the self-
leveling tube back into the cart.
Springs
Bottom Hook Bracket
Spring Hooks
Lift entire tube out of
cabinet to adjust springs
CAUTION :
Unplug cabinet and
allow to cool com-
pletely before adjusting spring
tension.
Fig. 1 Fig. 2
NOTE: Due to the varying weights and dimensions of bases and dinnerware, further spring
adjustments may be needed to achieve proper height and function.
6