Bakers Pride VG8/C - Manual (Page 12)

12
NOTICE:
THE COMBINATION OF FACTS, DATA, DESIGN ELEMENTS, ENGINEERING DATA, MANUFACTURING DATA & ASSEMBLY DATA
WHICH MAY BE CONTAINED IN THIS DOCUMENT ARE OF A PROPRIETARY NATURE TO BKI.
THESE MATERIALS ARE NOT TO BE USED OR COPIED WITHOUT PRIOR WRITTEN PERMISSION FROM BKI.
ALL RIGHTS ARE RESERVED.
To Cook.
Follow on from Pre-Heat with a short press on the stop button, This will pause the oven (heat is
“OFF”, and fans will stop after 20 seconds), wait until the fans stop before opening the door to load
the product.
Load the product into the oven using the rotation switch to stop & start the rotation, close the door
and press the Cook button, the display area will show the set temperature and the cook time will
start to count down.
OR
(if the oven is close to, or above the required cook temperature)
Select a program number
Wait until the Prog & Cook button lights go out, load the oven and then press the Cook button to
start program.
(Cook details will re-appear and timer will start to countdown)
We would strongly advise that you always pre-heat the oven, especially when cooking full loads!
The controller will automatically change between Stage-1 & Stage-2 (if programmed) and the
display will show the total cook time once the cook cycle has been started.
When the cook cycle has finished the buzzer sounds and the oven switches into the Hold mode (if
programmed).
To cancel the buzzer, press the Cancel Alarm button (white down arrow).