COATS 1175 Series Balancer - Manual (Page 13)

Important: Always read and follow the instructions. • 7
Exact Positioning of the Adhesive Weight
by Means of the Gauge with Clips
- press
- Fit the correction weight in the specific gauge seat
with the adhesive part facing upwards.
- bring the wheel into correct angular position for the
plane to be corrected
- withdraw the gauge until the correction plane indi-
cation arrows turn green
INSIDE CORRECTION POSITION
OUTSIDE CORRECTION POSITION
- Rotate the gauge until the correction weight adheres
to the rim
- the fact that the weight application position is no
longer vertical (Fig.8) is automatically compensated
- to cancel this function, press button
again
Result of Measurement
After performing a balancing spin, the amounts of
unbalance are shown on the digital readouts.
The illuminated LEDs 3 and 4 indicate the correct
angular position of the wheel to mount the counter-
weights (12 o’clock).
In the unbalance is less than the threshold valve
selected,
0
is displayed instead of the unbalance
value, with the values below the threshold
can be read.
Recalculation Of The Unbalance
Automatic on pressing the button.
Correction of inner side
Correction of outer side
FI FE